Create infill members
In order to quickly place a pattern of infill members into selected plays in a level, sloped plane, or frame, you can use the Create Infills command.
Note: Infills can only be created within four sided enclosed bays with members or
meshed/mid-pier shear walls attached to all sides. All suitable bays are shaded
green when Create Infills is selected.
Restriction:
You cannot create infills in 3D views.
Define the infill properties and pattern
Place the pattern in a single bay
Note: Infills can only be created within four sided enclosed bays with members or
meshed/mid-pier shear walls attached to all sides. All suitable bays are shaded
green.
- Hover the mouse pointer over the required bay, adjacent to the required edge member.
- If necessary, change the orientation by moving the cursor to a different edge member, or by adjusting the general parameters in the Properties window.
- Click the bay to create the pattern.
Place the pattern in multiple bays
Note: Infills can only be created within four sided enclosed bays with members or
meshed/mid-pier shear walls attached to all sides. All suitable bays are shaded
green.
- Drag a box around the required bays to select them.
- Hover the mouse pointer over one of the bays, adjacent to the required edge member.
- If necessary, change the orientation by moving the cursor to a different edge member, or by adjusting the general parameters in the Properties window.
- Click to create the same pattern in all the selected bays.