Engineering library update - October 2024
Tekla Tedds engineering library update
(October 2024 - version 26.07) can be downloaded and installed by going to Tekla
Downloads and clicking on the appropriate 
American Design
Masonry wall section design (TMS)
New si unit version of the calculation added.
Enhanced to use T section method for partially grouted, reinforced walls and various minor bug fixes and enhancements including additional reinforcement placement checks and flexibility, interaction diagram and sketch improvements.
Product bulletin June 2024 (PBT-2406-3)
Masonry section design (TMS) - Corrected a potentially un-conservative error affecting sections not being checked for combined axial and bending where only axial force and an eccentricity was specified. For more detailed information please refer to Product bulletin June 2024 (PBT-2406-3).
Product bulletin October 2024 (PBT-2410-1)
Masonry section design (TMS) - Corrected a potentially un-conservative error affecting the check of minimum vertical reinforcement when horizontal reinforcement is present. For more detailed information please refer to the Product bulletin October 2024 (PBT-2410-1).
Product bulletin October 2024 (PBT-2410-2)
Masonry section design (TMS) and Masonry wall panel design (TMS/MSJC) - Corrected a potentially un-conservative error affecting the calculation of the shear area of ungrouted, hollow, face bedded walls. For more detailed information please refer to the Product bulletin October 2024 (PBT-2410-2).
Product bulletin October 2024 (PBT-2410-3)
Masonry section design (TMS) and Masonry wall panel design (TMS/MSJC) - Corrected a potentially un-conservative error affecting the calculation of the axial stress partially grouted reinforced walls. For more detailed information please refer to the Product bulletin October 2024 (PBT-2410-3).
Other Updates
|
RC 2D analysis & design (ACI318) RC beam analysis & design (ACI318) RC beam design (ACI318) |
|
|---|---|
| TEDDS-8735 | Fixed summary table and sketch not matching output for moment resistance of doubly reinforced sections |
Australian Design
Updates
| Pad footing analysis and design (AS3600) | |
|---|---|
| TEDDS-9004 | Added missing calc item, 'Sliding summary check res' |
|
RC 2D analysis & design (AS3600) RC beam analysis & design (AS3600) RC beam design (AS3600) |
|
|---|---|
| TEDDS-8665 | Fixed values of disabled controls in the reinforcement dialog when designing a left hand side cantilever with reinforcement layout 2 selected |
| Steel beam analysis & design (AS4100) | |
|---|---|
| TEDDS-8978 | Corrected value of end moment ratio, bm, used for beams with transverse loads. |
British Design
Updates
| Pad footing analysis and design (BS8110) | |
|---|---|
| TEDDS-9004 | Added missing calc item, 'Sliding summary check res' |
Canadian Design
( No updates )
Eurocode Design
Updates
|
RC 2D analysis & design (EN1992) RC beam analysis & design (EN1992) RC beam design (EN1992) |
|
|---|---|
| TEDDS-8665 | Fixed values of disabled controls in the reinforcement dialog when designing a left hand side cantilever with reinforcement layout 2 selected |
| Retaining wall analysis & design (EN1992/EN1996/EN1997) | |
|---|---|
| TEDDS-8960 | Corrected preview results for unfactored bearing pressure check. |