Tekla Tedds Engineering Library (December 2020)
Link to download
Environment
Australia
Canada
Eurocode
USA
Materials
Concrete
Masonry
Timber/Wood
On this page
Back to top
Timber member design (EN1995)
UK and Asia
Wind loading (EN1991)
Enhanced to include support for the National Annex of Singapore.
Other updates
Masonry bearing design (EN1996)
[TEDDS-5056]1 - Fixed hef being used in initial eccentricity of vertical loading.
Masonry column design (EN1996)
[TEDDS-4345]1 - Fixed divide by zero error with small vertical loads.
Enhanced to include the option to omit vertical loading check when design small vertical loads.
Precast concrete beam design (EN1992)
[TSD-8247]1 - Added the ability to omit the web/flange longitudinal shear check by setting the change in moment to 0kNm or length under consideration to 0mm.
RC beam design (EN1992)
[TEDDS-5016]1 - Enhanced to include the option to include a results summary table in the output.
Timber member design (EN1995)
Timber stud design (EN1995)
Timber rafter design (EN1995)
Timber joist design (EN1995)
[TEDDS-5126]1 Fixed 'updateLockedSection' error when modifying the section for a rafter, stud or joist element.
Back to top
RC beam design (ACI318)
USA
Updates
RC beam design (ACI318)
RC beam analysis & design (ACI318)
RC 2D analysis & design (ACI318)
[TEDDS-4981]1 - Corrected the output statement when using the minimum exception rule and a negative moment occurs.
[TEDDS-5016]1 - Enhanced to include the option to include a results summary table in the output.
Back to top
Timber member design (EN1995)
Europe
Updates
Precast concrete beam design (EN1992)
[TSD-8247]1 Added the ability to omit the web/flange longitudinal shear check by setting the change in moment to 0kNm or length under consideration to 0mm.
RC beam design (EN1992)
[TEDDS-5016]1 - Enhanced to include the option to include a results summary table in the output.
Timber member design (EN1995)
Timber stud design (EN1995)
Timber rafter design (EN1995)
Timber joist design (EN1995)
[TEDDS-5126]1 Fixed 'updateLockedSection' error when modifying the section for a rafter, stud or joist element.
Back to topAustralia
Updates
RC beam design (AS3600)
[TEDDS-5016]1 - Enhanced to include the option to include a results summary table in the output.
Back to top
Canada
Updates
2D Analysis
[TEDDS-3770]1 Fixed Inertia values not being populated when selecting a Pipe section from the Canadian data list.
Footnotes
1 This number is an internal reference number and can be quoted to your local Support Department should further information on an item be required.
Back to top