XS_SINGLE_DIMENSION_TYPE
Category in Advanced options dialog: Single-part views in assembly drawings
Use to set a dimension type for single-part views included in assembly drawings. The options are:
-
1 =
Relative, point to point
dimensions. This is the default value. -
2 =
Absolute, dimensions from
a common start point. -
3 =
Relative and absolute, a
combination of point to point and common start point. -
4 =
US absolute, dimensions
from a common start point, which include a running dimension mark (RD). -
16 =
US absolute 2, similar to
US absolute, but it changes short dimensions to relative. -
35 =
Absolute plus short
relatives, which is similar to Absolute, but it changes short dimensions to
relative. Also called internal absolute. This option may show both
dimensions, but it does not show relative dimensions when dimensions are
long. This option shows the absolute dimensions inside the dimension lines. -
99 =
Absolute plus all
relatives above the absolutes, which is similar to Relative and absolute,
but it places the relative dimensions above the absolute.
This advanced option is model specific and the setting is saved in the options database. Reopen the model to activate the new value.