If a part is behind another part in the drawing so that it is hidden, you can select whether to show the mark frame and leader line of the hidden part with a dashed or a solid line.

1. On the Drawings & reports tab, click Drawing properties and select the drawing type.
2. Load drawing properties that are as close to the ones you need as possible.
3. Single-part, assembly and cast unit drawings: Click View creation in the options tree on the left, select the view and the properties that you want to change, and click View properties.
4. Click Part mark.
5. In part mark properties, go to the General tab.
6. Use one of the following options:

   Use hidden lines for hidden parts: Yes

   Part mark frame and leader line are shown with a dashed line.

   

   Use hidden lines for hidden parts: No

   Part mark frame and leader line are shown with a solid line.

   

7. Single-part, assembly and cast unit drawings: Click Save to save the changes in view properties and Close to return to drawing properties.

   General arrangement drawings: Click OK.

8. Click Save to save the drawing properties, then click OK and create the drawing.