Show a single rebar in a group

Tekla Structures
2024
Tekla Structures

Show a single rebar in a group

You can show one rebar in a group or in a mesh and hide the rest.

  1. In an open drawing, select a rebar group or mesh.
  2. Go to Quick Launch, type Adjust Reinforcing Bars, and click the Adjust reinforcing bars command on the displayed list.
  3. Click the rebar you want to remain visible.

    Only one bar is displayed, and the others are hidden.

    When you use the Adjust Reinforcing Bars command to select the visible reinforcing bar, the customized option becomes available in the Bars in groups option list in rebar properties in the property pane. Note that this option is only available after you have used the Adjust reinforcing bars command and not when you define the drawing settings before you create the drawing, for example.

  4. If you want to adjust the location of a single reinforcing bar, right-click the reinforcing bar group, and click Adjust location.

    You can only adjust the bar location in one direction inline with other group members.

  5. Click the location where you want to place the bar.
  6. If needed, change the number of visible bars again by clicking the bar and changing the setting to all in rebar properties, for example.

Example

Was this helpful?
Previous
Next