Set a new dimension start point

Tekla Structures
2023
Tekla Structures

Set a new dimension start point

You can select a new start point for running dimensions (dimensions that start from a common start point).

  1. Select an existing dimension in a drawing.
  2. On the Dimensioning tab, click Set start point.
  3. Select the new start point.

    Tekla Structures automatically updates the dimensions.

Example

You can use this command to swap the running dimensions start point to the opposite end of the member.

When you use the US absolute dimension type, Tekla Structures draws a new RD symbol (Running Dimension) at the new zero point and updates the dimensions according to the new start point.

Was this helpful?
Previous
Next