XS_REBARSET_CREATION_ANGLE_TOLERANCE_FOR_CROSSING_REBARS

Tekla Structures
2022
Tekla Structures

XS_​REBARSET_​CREATION_​ANGLE_​TOLERANCE_​FOR_​CROSSING_​REBARS

Category in Advanced options dialog box: Concrete detailing

Use this advanced option to define the tolerance for the angle between consecutive part faces when the rebar set bars are created. If the angle between a part face and the extension of the previous part face is less than the value of this advanced option, a rebar set leg face is created at the part face.

This advanced option applies to the rebar sets when they are created using the Create crossing rebars command. The default value is 45 (degrees).

This advanced option is model specific and the setting is saved in the options database.

Was this helpful?
Previous
Next