XS_HOLE_MARK_STRING_FOR_SIZE_IN_GA

Tekla Structures
2022
Tekla Structures

XS_​HOLE_​MARK_​STRING_​FOR_​SIZE_​IN_​GA

Category in Advanced options dialog box

Marking: Bolts

Use to define the contents of the size element in bolt marks in general arrangement drawings. If you have not set the advanced options XS_SHOP_HOLE_MARK_STRING_FOR_SIZE_IN_GA or XS_SITE_HOLE_MARK_STRING_FOR_SIZE_IN_GA, then this advanced option is used.

This advanced option is only used when there is a hole, no bolt (and the hole is a normal one).

You can use any combination of text and the following options as the value for this advanced option. Enclose each option in % characters.

Note that if you are defining this advanced in an .ini file, use double percent signs around the switches %%BOLT_NUMBER%%*D%%HOLE.DIAMETER%%.

To use special characters enter a backslash (\) followed by an ASCII number. You can use the options in any order, and make calculations.

  • BOLT_NUMBER

  • DIAMETER

  • LENGTH

  • HOLE.DIAMETER

  • LONG_HOLE_X

  • LONG_HOLE_Y

  • LONGHOLE_MIN (the shorter of the slotted hole dimensions)

  • LONGHOLE_MAX (the longer of the slotted hole dimensions)

  • BOLT_STANDARD

  • BOLT_MATERIAL

  • BOLT_ASSEMBLY_TYPE

  • BOLT_COUNTERSUNK

  • BOLT_SHORT_NAME

  • BOLT_FULL_NAME

This advanced option is model specific and the setting is saved in the options database.

See also

XS_​SHOP_​HOLE_​MARK_​STRING_​FOR_​SIZE_​IN_​GA

XS_​SITE_​HOLE_​MARK_​STRING_​FOR_​SIZE_​IN_​GA

Define size in bolt marks using advanced options

Was this helpful?
Previous
Next