Category in Advanced options dialog box

Modeling Properties

Cleans away system component provided contour plate profile points in cases where points are on an almost straight line if the provided (middle) points deviate from the line at most as much as the value of this advanced option. The point is then so close to the line between the previous and next point that it is redundant and can be removed. Enter a decimal value. The default is 1.0 mm.

This advanced option is model specific and the setting is saved in the options database.

See also

XS_CONTOUR_PLATE_POINT_ON​_SAME_LINE_LIMIT_FOR​_​CLOSE_​POINTS