Create a single reinforcing bar
-
On the Rebar tab, click
Single bar.
If you need to modify the properties before you create the reinforcement, hold down Shift and click the Single bar command to open the Single rebar properties.
- Select the part to reinforce.
- Pick the bar start point.
- Pick the other bar reference points to set the bar shape.
-
Click the middle mouse button to finish picking.
Tekla Structures attaches the bar to this part.
-
If you want to modify the reinforcement,
do one of the
following:
-
Use direct modification. Ensure that the Direct modification switch is active.
-
Double-click the reinforcement to open the Single rebar properties and modify the properties.
-