Create a curved reinforcing bar group
You can reinforce curved segments in a concrete beam or a curved wall.
On the Rebar tab, click .
If you need to modify the properties before you create the reinforcement, hold down Shift and click the Curved group command to open the Curved bar properties.
Select the part to reinforce.
Tekla Structures attaches the bar group to this part.
Pick three points on an arc to define the curve.
Pick two points to indicate the distribution direction of the bars.
Tekla Structures creates a group of curved reinforcing bars.
If you want to change the curved reinforcing bar group properties:
- Double-click the curved reinforcing bar group to open the Curved bar properties.
- Modify the properties.
- Click Modify.