Ungroup a reinforcement

Tekla Structures
2021
Tekla Structures

Ungroup a reinforcement

You can ungroup reinforcing bar groups and reinforcement meshes. Only reinforcement where each reinforcing bar is in one plane can be ungrouped.

Note:

You cannot ungroup circular or curved reinforcing bar groups.

  1. On the Rebar tab, click Edit > Group.
  2. Select one of the reinforcing bars in a reinforcing bar group or in a reinforcement mesh.

    The reinforcing bar group is replaced with single reinforcing bars. The single bars get the same properties and offsets as the group.

    If you ungroup a reinforcement mesh, the offsets for single bars are zero.

    Before ungrouping After ungrouping

Was this helpful?
Previous
Next