Refresh drawing associativity after cloning

Tekla Structures
2021
Tekla Structures

Refresh drawing associativity after cloning

Often improvements in cloning and associativity require that the associative rules have to be recreated. This can be done by using the Refresh associativity command. When you use this command, you do not need to recreate the drawing.

For example, this command is very useful if you have a cloning template you have created using an older Tekla Structures version and want to utilize the better associativity of a newer Tekla Structures version.

  1. On the Drawings & reports tab, click Document manager.
  2. Open a cloning template the associativity of which you want to refresh.
  3. Go to Quick Launch, enter Refresh associativity, and click the Refresh associativity command on the displayed list.
  4. Save the cloning template.
Was this helpful?
Previous
Next