Single-part, assembly and cast unit drawings:
|
-
Click
View creation in the options tree on the left, select the view and the properties that you want to change, and click
View properties.
-
Click a mark type in the options tree. For example, click
Part mark.
-
Go to the
General tab and select whether you want to display marks by selecting one of the
Visibility in view options. The available options depend on the mark type:
-
distributed: Distributes the marks in the view.
Tekla Structures only creates marks that are not visible in the other views.
-
always: Always creates marks in the view, irrespective the settings in other views.
-
preferred: Acts as distributed, but the preferred view has a higher priority.
Select
preferred to one view only in a drawing. If you set other views to
distributed, the marks are located only in the view that has the setting
Visibility in view set to
preferred.
-
none: Does not create marks.
Note that if you want to create your own marks manually, always use the
none option. Selecting another option, for example
always, might slow down the drawing update during opening, even if you had deleted the marks manually.
-
In
Parts out of view plane, select whether you want to display marks for parts that are out of view plane:
-
For bolt marks, select if you want to show bolt marks in main parts, secondary parts, sub-assembly main parts, or in sub-assembly secondary parts.
For bolt marks, you can also define the
Ignore size, which filters standard-sized bolt marks out of drawings.
Tekla Structures will not display bolt marks of the size you enter here.
-
Click to save the changes in view properties, and then click
Close to return to drawing properties.
-
Click
Modify.
|
General arrangement drawings:
|
-
Click a mark type button in drawing
properties. For example, click Part mark....
-
Go to the
General tab and select whether you want to display marks by selecting one of the
Visibility in view options. The available options depend on the mark type:
-
distributed: Distributes the marks in the view.
Tekla Structures only creates marks that are not visible in the other views.
-
always: Always creates marks in the view, irrespective the settings in other views.
-
preferred: Acts as distributed, but the preferred view has a higher priority.
Select
preferred to one view only in a drawing. If you set other views to
distributed, the marks are located only in the view that has the setting
Visibility in view set to
preferred.
-
none: Does not create marks.
Note that if you want to create your own marks, always use the
none option. Selecting another option, for example
always, might slow down the drawing update during opening, even if you had deleted the marks manually.
-
In
Parts out of view plane, select whether you want to display marks for parts that are out of view plane:
-
For bolt marks, select if you want to show bolt marks in main parts, secondary parts, sub-assembly main parts, or in sub-assembly secondary parts.
For bolt marks, you can also define the
Ignore size, which filters standard-sized bolt marks out of drawings.
Tekla Structures will not display bolt marks of the size you enter here.
-
Click
OK.
-
Click
Modify.
|