Add manual dimensions to general arrangement drawings
You can dimension parts to grids along their X, Y, or X and Y axis and along grid lines in general arrangement drawing plan views.
Limitation: Parts like beams that are not located along the grids are not dimensioned.
- Open a general arrangement drawing.
- To check and change the dimension properties, on the Drawing tab, click , make the necessary changes and click Apply or OK.
Dimensioning tab, click
GA dimensions and the click one of the following commands:
To dimension along grid lines, click Add dimensions along grid lines and pick the view in the location where you want to create the dimensions.
To dimension along part X or Y axis or both, select the part, and click Along part X axis, Along part Y axis or Along part X and Y axis. The parts are dimensioned to the two nearest grids.
Tekla Structures creates the dimensions according to the dimension properties you defined in the Dimension Properties dialog box.
For instructions on how to dimension reinforcement in GA drawings, see Add dimensions to reinforcement.