3D cut (10)
The 3D cut (10) component creates a 3D cut to a concrete part. The cutplane is determined by picking three points on the (concrete) part edges. The cut direction can be set. Also an cut offset can be set.
Use for
|
Situation |
More information |
|---|---|
|
|
This component creates a cut through three points. The side to be removed can be defined. |
Before you start
Before applying the macro, create the following part:
-
Concrete part (panel, column, strip footing)
Defining properties
The component contains only one tab, named Picture.
|
Tab |
Content |
|---|---|
|
Picture |
Defining the cut direction. Possibly set an cutplane offset. |
Picking order
-
Concrete part.
-
Three points to determine the cut plane.
Picture tab
You can define the following settings on the Picture tab.
Cut type
| Option | Description |
|---|---|
|
Cut right |
The parts’ right side from the cut plane will be removed. |
|
Cut left |
The parts’ left side from the cut plane will be removed. |
|
Fit plane |
The removed part is the shortest part (from fit plane to part’s end). |
|
No cut |
No cut is applied. |
Offset
You can define the offset for the cut plane. The offset distance is always perpendicular to the cut plane.
Explode component
You can select to explode the component if you do not need to modify the component after applying it. If you plan to modify the component later, select not to explode it.