Define the properties of a load
Before you create a load, it is a good idea to define or check the load properties.
Tekla Structures uses these properties when you create new loads of this type.
Before you create a load, it is a good idea to define or check the load properties.
For example, click Area load to define area load properties.
Select a load group.
Define the load magnitude, and the load form if needed.
Attach the load to a part or to a position.
You cannot attach a load to a part after you have created the load.
You can detach a load from a part after you have created the load.
Define the load-bearing parts.
If needed, adjust the loaded length or area.
If needed, modify the load distribution on the Load panel tab.
Tekla Structures uses these properties when you create new loads of this type.