XS_​CENTER_​LINE_​TYPE

Tekla Structures
2019
Tekla Structures

XS_​CENTER_​LINE_​TYPE

Category : Drawing Properties

Drawing Properties

Use this advanced option to change the line type of the part center lines in drawings. Enter an integer value from 1 to 7. To see the center line type change, close the drawing and open it again.

You can select whether to show the center line in Part properties.

Value

Description

1

Solid line

2 - 7

Dotted lines.

The default value is 4 (dash-and-dot line).

If you enter a value that is lower than 1 or higher than 7 , Tekla Structures uses the default value 4.

Tip:

To see what the line types look like, see the Hidden lines > Type options on the Appearance tab in Part Properties.

For a list of default line types, see Default line types in drawings (old export).

This advanced option is model specific and the setting is saved in the options database.

Was this helpful?
Previous
Next