Unitechnik export: Pallet tab

Tekla Structures
2019
Tekla Structures

Unitechnik export: Pallet tab

Use the Pallet tab to control the Unitechnik export properties.

Option

Description

Placing on pallet

Define if the placing is checked from the start or end of the pallet.

X offset at start or end

Define if the X offset at start or end of the pallet is checked.

Y offset from alignment

Specify the Y offset of elements on the pallet.

Align in Y axis

Align elements in Y direction. You can select whether to align

  • element upper edge to pallet upper edge
  • element upper edge to pallet center line
  • element center line to pallet center line
  • element lower edge to pallet center line
  • element lower edge to pallet lower edge

Clearance between cast units

Define if the clearance between the cast units is checked.

Same cast unit thickness needed

Define if the cast unit thickness is checked.

Sequence in pallet

Sequence order

When you have selected Combined, n slabdate, 1 part as the output file structure on the Main tab, you can select the logic of sequencing panels on pallet using main part or cast unit ACN or number, main part UDA or main part template, or Unitechnik transport UDAs. You can set the sequence as Ascending or Descending.

Was this helpful?
Previous
Next