Export line attributes for contour | Select whether the line attribute values are used for contours ( Export line attributes for contour ) or for holes ( Export line attributes for cutouts ) in the export. None Line attribute values are not used. All lines Line attribute values are used for all lines. Outmost lines only Line attribute values are used only for the outermost lines in the part:
This option is available only for contours. |
Border line overriding | You can enter up to six border line modifications in the line attribute export. |
No border lines are overridden. |
Vertical outermost border lines at the start are overridden. |
Horizontal outermost border lines at the bottom are overridden. |
Vertical outermost border lines at the end are overridden. |
Horizontal outermost border lines at the top are overridden. |
Vertical outermost border lines are overridden. |
Horizontal outermost border lines are overridden. |
Horizontal and vertical outermost border lines are overridden. |
| All inclined outermost border lines are overridden. |
All outermost border lines are overridden. |
All vertical border lines, except the outermost border lines are overridden. |
All horizontal border lines, except the outermost border lines are overridden. |
All vertical and horizontal border lines except the outermost border lines are overridden. |
All border lines except outermost border lines are overridden. |
All border lines except the horizontal and vertical outermost border lines are overridden. |
All border lines are overridden. |
Orig. attr, New attr. | Define the original attribute ( Orig. attr ) and the attribute that will be used in the export ( New attr. ). In the example below the horizontal outermost border line at the top would get a line attribute value 0033 originally, but the value will be overridden, and the line attribute value in the Unitechnik file will be 0040. |
Export line attributes for cutouts | Select whether all line attributes are exported for openings. |
Export angle of 1st and last vertical border | Select whether you want to export the angle of cut at the first and last vertical border. |
Max , Min | The width of the chamfer is max 30 mm and the depth of the tongue and groove max 30 mm. If not within the tolerance, they are handled as special formwork 0002. |