XS_​DRAWING_​ALLOW_​SNAPPING_​TO_​DISTANT_​POINTS

Tekla Structures
2018
Tekla Structures

XS_​DRAWING_​ALLOW_​SNAPPING_​TO_​DISTANT_​POINTS

Category

Drawing Properties

Set this advanced option to TRUE to allow the cursor to snap to object end points in a drawing even if the cursor is not near the end point. This means that if the cursor is anywhere on the object, the cursor will snap to the object end points. If you do not want to allow this, set this advanced option to FALSE. Then the cursor will snap only to the snap points near the cursor.

The default value is FALSE.

This advanced option is user specific and the setting is saved in options.bin under user folder. Restart Tekla Structures to activate the new value.

Was this helpful?
Previous
Next