All drawing views can have view labels, which may contain text and symbols. You can set the contents of the main view labels and section view labels before you create the drawing. You cal also adjust them after you have created the drawing.
- On the Drawings & reports tab, click Drawing properties and select the drawing type.
- Load drawing properties that are as close to the ones you need as possible.
- Do one of the following depending on the drawing type:
Single-part, assembly and cast unit drawings:
- Click View creation , select the view and the properties that you want to change, and click View properties.
- Click Attributes and go to the Label tab.
General arrangement drawings:
- Click View.
- Go to the Label tab.
- Click the ... button next to A1 - A5 to open the Mark Contents dialog box.
The illustration in the view properties dialog box is only one way to position the label text. When you modify the positioning, the illustration in the dialog box does not change.
- On the Content tab, select the elements that you want to include in the view label mark.
- If needed, select an element from the list and click Add frame and select the frame Type and Color.
- If needed, select an element from the list and select the text Color , Font and Height.
- Go to the Position tab and set the text position, horizontal and vertical offset, and the text alignment.
Text positioning depends on whether you use a symbol or not.
- Click OK.
- Select the view label Symbol you want to use in the label.
You can simply use only a label or add a symbol in it. You can also set the color, size, line length and the position of the view label.
- Select the position for the view label: Vertical ( Above or Below ) and Horizontal ( Center by view frame or Center by view restriction box ).
- To save the changes, click Save.
- Single-part, assembly and cast unit drawings: Click Close.
General arrangement drawings: Click OK.
- Click Save to save the drawing properties, then click OK and create the drawing..
See below for examples of view labels:
Drag the view label to the desired page in an open drawing.
The view frame is resized automatically, if necessary.
Define section view properties for all views in a drawing
If you want to use the same section view properties, such as start number or letter, cutting line, contents, and text position, in all your section views, you can do this in on the drawing level. For more information, see Define automatic section view properties.