Add frames and fold marks in printouts

Tekla Structures
2018
Tekla Structures

Add frames and fold marks in printouts

You can add frames and fold marks in printed drawings. Fold marks indicate the locations where the printouts should be folded. You can select a color for the frames and fold marks.

Drawing frames and fold marks are controlled in the standard.fms file under the \system folder. There is no saving option in the Drawing Frame Properties dialog box, which is why the default values are located in a standard file. You can save the standard file in the model folder, and then copy it to the project or firm folders, if needed. If you want to save a set of standard files in the model folder, see Standard files.

  1. Start typing Drawing frames and foldmarks in the Quick Launch box in the upper-right corner of the Tekla Structures main window, and select it from the displayed list.
  2. In the Drawing Frame Properties dialog box, select the check boxes of the frames you want to print.
  3. In Margins , enter in millimeters the distance between each frame and the left, right, bottom, and top edge of the paper.
  4. Select a color for each frame.
  5. To print the fold marks, select the Foldmarks check box.
  6. Enter in millimeters the horizontal and vertical distances of the first fold marks from the lower right corner of the outer frame, and between the other fold mark.
  7. Select a color for the fold marks.
  8. Click OK.

Below is an example of the properties dialog box contents and the standard file.

Note:

There is a fixed distance value of 5 mm in drawing frame margins. Thus, if you want to use a drawing frame margin with a drawing title that sticks to the frame corner, you need to change not only the drawing frame margin in the Drawing Frame Properties dialog box, but also the Vector between corners in the Tables dialog box ( Drawings & reports > Drawing properties > Drawing layout > Table layout... > Tables... ).

Was this helpful?
Previous
Next