Tekla Structures 2025 India Environment Release Notes

1.1 Modeling

1.1.1 Sketched Profile:

The below 3 sketched profiles are uploaded into Tekla warehouse.(Click Here)

a) BEAM

Image

b) CBEAM

Image

c) CORBEL    

Image

1.1.2 Bridge Creator:

2 IND attributes created based on the available 2 cross section (Sample and Lang set).

Attribute names :

IND_Langset (4 refs)

IND_Sample (1 ref)

Image

Notes : Add a straight construction line to read by using “Read alignment “

1.1.3 Tekla PowerFab

The below attributes are added.

Estimating_Tekla_PowerFab

Drawing_Tekla_PowerFab

Estimating_Bolts.estimatingsettings

Estimating_Tekla_PowerFab

Estimating_Without_Bolts

EX_Approval_DWG

Fabrication_Tekla_PowerFab

Procurement_Tekla_PowerFab

Procurement_Tekla_PowerFab

Tekla_PowerFab_DWG

Tekla_PowerFab_DWG_NC

Tekla_PowerFab_Without_DWG_NC

Image

1.2 Components / Connections

System Components:

There are a few connection attributes added for Steel components.

1.2.1 Component Name: Haunch (40)

Attribute name: IND_Extraplates_Offest.j40

It is now possible to specify horizontal offset for the upper and lower bolt plates.

1.2.2 Component Name: Wraparound gusset cross (60)

Attribute name: IND_Gusset_Clip angle_Clearence.j60

It is now possible to specify erection clearance between angles and gusset.

1.2.3 Component Name: Bolted gusset (11), Tube gusset (20) and Gusseted cross (62)

Attribute name: IND_Gusset_Through_MainPrt_2.j11

It is now possible to specify gusset plate extension dimension from the opposite face when gusset runs through the main part.

1.2.4 Component Name: Stiffened end plate (27)

Attribute name: IND_Parameters_Offset.j27

It is now possible to specify offset for the shear plate and stiffener plate.

1.2.5 Component Name: Welded gusset (10)

Attribute name: IND_Round Notch.j10

It is now possible to create rounded notch in the secondary parts.

1.3 Reports

IND_Strand_List.rpt report added                                                                                                                          

Image

1.4 Drawings

The below attribute files modified due to the improvements in the line appearance.

standard.vi

standard.dprt

standard.vi.filter

standard.vnp

standard.vp

Image

The below attributes are added for drawings templates and drawing layout.

Similar_Rebar_Assembly.tpl

Rebar Assembly dwg layout.lay 

Image