Run Analyze All (Static)
Static designs can only be performed provided suitable analysis results exist - while these results are created when you run a combined analysis and member design, in some situations you may prefer to run the analysis separately and then selectively design parts of the model as required.
The Analyze All (Static) process facilitates this as it performs all the analyses for static loadcases and active static load combinations that are required to enable the selective designs to be carried out.
As indicated in the table below, the analyses included in the process vary according to the model content and the options specified on the Analysis page of Design Settings.
|
Analysis type |
Included in Analyze All (Static)? |
|---|---|
| 1st order 3D analysis (linear or non-linear)* |
Always included |
| 2nd order analysis (linear or non-linear)* |
Included if second-order analysis has been specified on the Analysis page of Design Settings |
| Grillage chasedown | Included if one or more concrete members exist |
| FE chasedown | Included if two-way spanning slabs exist |
|
1st order staged construction analysis (linear or non-linear)* or 2nd order staged construction analysis (linear or non-linear)* |
According to if ‘First-order’ or ‘Second-order’ analysis and ‘Include staged
construction analysis’ have been specified on the Analysis page of Design
Settings If ‘Include staged construction analysis’ have been specified on the Analysis page of Design Settings this will be included (as 1st or 2nd order according to the 'Analysis' setting on the same page.) |
| * If the model contains non-linear elements the analysis will be non-linear, otherwise it will be linear | |
To run Analyze All (Static):
-
On the Analyze ribbon, click
Analyze All (Static).
At the end of the analyses if a 2D or 3D view is active it is switched to a Results View.