Use the Show/Alter State command Punch check position attribute in a Review View to graphically modify the assumed punching shear check position so as to determine the loaded perimeter when the perimeter is close to a free edge.

1. Open a view and switch the view regime to Review View.
2. On the Review ribbon, click Show/Alter State.
3. Go to the Properties window.
4. In the Attribute list, select Punch check position.
5. To change the punching shear check position, do one of the following:

   To	Do this
   Switch the punching shear check position between Edge Z and Internal	Click the Z edge of a punching check item.
   Switch the punching shear check position between Edge Y and Internal	Click the Y edge of a punching check item.
   Switch the punching shear check position between Corner, Edge Z, Edge Y and Internal	Click a corner of a punching check item.

   Note:

   Clicking an internal punching check item does not change the punching shear check position.

   Tip:

   You can also box around multiple punching check item to switch their position. Do one of the following:

   • Hold down the left mouse button and drag a box from left to right to switch the position setting of all punch check items within the box.
   • Hold down the left mouse button and drag a box from right to left to switch the position setting of all punch check items within the box or cut by the box.