Design settings
Click to edit the following design settings specific to the current model.
After they have been edited, click Save, Load, Cancel, or OK according to your requirements.
Click and then select the Design Settings page in the dialog to edit the Global settings.
- Analysis
- General
- Steel > General (Eurocode only)
- Steel > Composite Beams
- Steel > Steel Joists
- Concrete (Cast-in-place)
- Concrete (Precast - Eurocode only)
- Design Forces
- Design Groups
- Autodesign
- Design Warnings (AISC/ASC only)
- Design Checks (IS only)
- Sway and Drift Checks
- Fire checks (Eurocode only)
- Design Settings > Timber