Check in Tedds (command)

Tekla Structural Designer
2022
Tekla Structural Designer

Check in Tedds (command)

Command Description
Check in Tedds

Located on the Design ribbon tab, this command can be used after any precast or timber members have been initially designed. It is intended for use where a general re-check for all objects is required following changes to the model which require a reanalysis process (e.g. changing the loading applied onto the model). The command finds all members where a linked Tekla Tedds calculation has been created and performs a check design for these members. This command should ideally be used at the end of the design cycle and ensures that the previously designed timber, or precast concrete elements still meet the design criteria of the model.

Note: Check in Tedds does not perform an analysis before the check - it always uses the latest existing set of analysis results, (even if the analysis status is 'Out of Date').
Was this helpful?
Previous
Next