Display analysis results in a Results View

To display graphical analysis results, first switch the view to the

Results View regime (1), then click the Results ribbon tab (2).

After selecting the analysis method (3) and loading (4), results can then be displayed by making selections from the ribbon.


Ribbon Group	Click the link to find out more
Reactions	Display reactions
1D Results	Display 1D results
	Display 1D deflections
	Animate 1D and 2D deflections
Sway Drift...	Display sway drift and story shear
Notional Loads	Display notional forces, minimum lateral loads and seismic equivalent lateral forces
2D Results	Display 2D results
	Display 2D deflections
	Animate 1D and 2D deflections
	Display AsReq contours
2D Integrated Results Note: Result lines and result strips must be created before they can be displayed.	Display wall lines
	Display core lines
	Manage, display and design result lines
	Manage and display result strips
Mode Shapes	Display mode shapes
RSA Results	RSA seismic results

If required, adjustments can be applied to the diagrams as follows:

To change contour intervals and colors, see Customize the display of 2D contours
To adjust the amplitude of the diagrams, see Change result diagram scale settings
In 2D views, it is sometimes necessary to switch to an isometric projection, see Display 2D view in isometric projection

Note: When Tekla Structural Designer has performed several analysis types, the results of each analysis are held separately. Therefore, there is no need to re-perform a particular analysis to recall its results.