Apply cantilever ends

Tekla Structural Designer
2021
Tekla Structural Designer

Apply cantilever ends

The Cantilever end command allows you to graphically apply cantilever ends where required to beams and columns.

  1. Open a view and change the view regime to Review View.
  2. On the Review tab, click Fixed/Pinned.
  3. Go to the Properties window.
  4. In the Attribute list, select Cantilever end.
  5. Set Mode to Set On, Set Off, or Toggle as required.
  6. Do one of the following:
    • Click an individual member end to set/unset a cantilever end as per the Mode.
    • Hold down the left mouse button and drag a box from left to right to alter the cantilever end settings of all members entirely within the box.
    • Hold down the left mouse button and drag a box from right to left to alter the cantilever end settings of all members within the box or cut by the box.
Was this helpful?
Previous
Next