Grouping settings

Tekla Structural Designer
2021
Tekla Structural Designer

Grouping settings

The Grouping page in the Model Settings dialog box allows you to control the tolerance applied when members are grouped in the current project.

Item Description

Maximum edge length variation

Allows for a tolerance to be applied to the automatic grouping. A member can only be included in an existing group if its span length is within the specified tolerance of the group's (average) span length.

Maximum length variation

Allows for a length tolerance to be applied to the automatic grouping of trusses. A truss can only be included in an existing group if its span length is within the specified tolerance of the group's (average) span length.

Maximum height variation

Allows for a height tolerance to be applied to the automatic grouping of trusses. A truss can only be included in an existing group if its height is within the specified tolerance of the group's (average) height.

Was this helpful?
Previous
Next