Apply member loads

Tekla Structural Designer allows you to create and apply the following types of member loads:

Full-length uniformly distributed loads (Full UDLs)
Partial-length uniformly distributed loads (UDLs)
Partial-length variable distributed loads (VDLs)
Trapezoidal loads
Point loads and moment loads
Full-length torsional uniformly distributed loads (UDLs)
Partial-length torsional uniformly distributed loads (UDLs)
Partial-length torsional variable distributed loads (VDLs)

The above loads can be applied to all one-dimensional member types apart from braces and truss internals, (these latter two types being prevented from having loads applied within their length).