Run a 2nd order buckling analysis
In order to run a buckling analysis on your model, see the following instructions.
On the Analyze tab, click Settings.
The Analysis Settings dialog box opens.
- In the dialog box, go to the 2nd Order Buckling page.
- If necessary, adjust the buckling options.
- Click OK.
Analyze tab, click
2nd Order Buckling.
The Select loading dialog box opens.
- In the Select loading dialog box, select the combinations and loadcases that you want to analyze.
Tekla Structural Designer analyzes the model.
At the end of the analysis process the Results View and the Results tab open to allow you review the analysis results graphically.