Run 3D only (Static)
3D only (Static) analysis can be used to save time during scheme design, for example while addressing overall stability, sway, drift, wind drift, etc.
To run a 3D only analysis proceed as follows:
On the Analyze tab, click 
3D only (Static).
3D only (Static).
Tekla Structural Designer performs the following 3D analyses:
- 1st order linear/non-linear
- 2nd order linear/non-linear (only if this has been specified by the user in Design > Design Settings > Analysis)
At the end of the analysis if a 2D or 3D view is active it is switched to a Review View.