Run a seismic analysis

Tekla Structural Designer
2020
Tekla Structural Designer

Run a seismic analysis

In order to run either a 1st or 2nd order seismic analysis on your model, see the following instructions.

Run a 1st order RSA seismic analysis

  1. On the Analyze toolbar, click Settings.

    The Analysis Settings dialog box opens.

  2. In the dialog box, go to the 1st Order Seismic page.
  3. If necessary, adjust the analysis options.
  4. Click OK.
  5. On the Analyze tab, click 1st Order RSA Seismic.

    Tekla Structural Designer analyzes the model.

    At the end of the analysis process, the Results View and the Results toolbar open, and allow you review the analysis results graphically.

Run a 2nd order RSA seismic analysis

On the Analyze tab, click 2nd Order RSA Seismic.

Tekla Structural Designer analyzes the model.

At the end of the analysis process, the Results View and the Results toolbar open, and allow you review the analysis results graphically.

Was this helpful?
Previous
Next