Filter information in the Production Control dialog box

Tekla PowerFab
Modified: 13 Mar 2023
2024i
Tekla PowerFab Tekla PowerFab GO

Filter information in the Production Control dialog box

In addition to using the navigation tree for filtering items, you can set filters that determine which items are shown in the Production Control dialog box. You can also save the filter settings for later use.

If the Open to Filter Selection checkbox has been selected in Maintenance > <Module> > Company Standards, the <Module> Filters dialog box opens automatically when you open a job.

If the Open to Filter Selection checkbox has not been selected, open the <Module> Filters dialog box as follows:

  1. In an open production control job, click the Production Control ribbon tab.
  2. On the menu, select Filter.

    The <Module> Filters dialog box opens.

  3. Select a filter type in the Type list and click Select.

    The Filter dialog box opens.

    For some filter types, you can also click Find and type the desired value in the search box to use it. This way, you do not have to scroll through all the available items.

  4. Click the arrow buttons to move the items that you want to display to the Included list.
  5. Click OK.

    If you want to further filter the information displayed , repeat steps 3 to 5 for different items. Note that only items that match the items in the Included list will be available when setting more filters.

    If you want to clear all filter settings, click Reset.

  6. Click Apply Filter.

The <Module> Filters dialog box closes, and the items are filtered according to the settings you made.

To display all information again, click Clear Filters in the upper-left corner.

To create and save commonly used filters, see Module-wide filters.
Was this helpful?
Previous
Next