Filters in Tekla PowerFab Go

When you are viewing a job in Tekla PowerFab Go, you can sort the information that is shown by applying filters.

You can filter job information by main mark, drawing number, sequence, lot number, and item category or sub-category. You can also modify the applied filters, set multiple filters, and clear the filters to view all job information again.

Set filters

In the job view, tap the Filters () button in the upper-right corner.

The filtering view opens.

To show the filter bar in the main view, toggle the Filter bar switch.
Select the filter that you want to apply from the drop-down menu.
Select the values that you want to use for filtering.

For example, if you want to filter the job information according to the drawing number, select the desired drawing numbers.

You can select multiple values.
Tap Apply.

Only information that matches the filters that you applied is shown.

To apply more filters, repeat steps 1 to 4.

Any currently applied filters are shown on the filter bar.

Modify filters

In the job view, tap the Filters () button in the upper-right corner.
To open the filtering view, tap the Filters () button.
On the drop-down list, select the filter that you want to modify.
Modify the values that you want to use for filtering.
Tap Apply.

Only information that matches the filters that you applied is shown.

Clear filters

Do one of the following

On the filter bar, to clear one filter, click the filter that you want to clear.
On the filter bar, to clear all filters, click Clear all.
Open the filter view () and use the filter bar to clear one or more filters.