Create an automated Trimble Connect synchronization event

Tekla PowerFab
2024
Tekla PowerFab Tekla PowerFab GO

Create an automated Trimble Connect synchronization event

  1. Go to Maintenance > Automated Events.

    The Automated Events dialog box opens.

  2. Click New Event.

    The Automated Event Details dialog box opens.

  3. Type a title and a description for the event.
  4. In the Event Type list, select Publish to Trimble Connect.
  5. To send an email if publishing the information to Trimble Connect fails:
    1. Click Failure Notifications.
    2. If you have not yet defined the outgoing email settings, do so on the Outgoing SMTP Server tab.
    3. On the Failure Notifications tab, type the email addresses to which you want to send a message if the automated database optimization fails.
      Note: You need to type each email address on a separate line.
    4. Click Save.
  6. Click Event Properties.

    The Automated Event Details dialog box opens.

  7. Click Event Properties.
    The Publish Status to Trimble Connect dialog box opens.
  8. Select which actions happen when the automated event is run:
    • Publish to Organizer: Publish jobs to Trimble Connect Organizer.
    • Publish to Status Sharing: Publish jobs to Trimble Connect Status Share.
    • Sync BCF Topics: Sync BCF Topics from Trimble Connect to Tekla PowerFab. See BCF Topics.
    • Push Projects: Publish project management jobs to the selected applications.

      You can select which jobs should be published by clicking Set Filter.

    • Push Estimates: Publish estimating jobs to the selected applications.

      You can select which jobs should be published by clicking Set Filter.

    • Push Production Control Jobs: Publish production control jobs to the selected applications.

      You can select which jobs should be published by clicking Set Filter.

  9. Click Save to save the actions to be published and the applied filters.
  10. To allow Tekla PowerFab to perform the event automatically, ensure that the Event Enabled checkbox is selected.
  11. Click Save to create the automated event.
Was this helpful?
Previous
Next