Take a single cut list item from stock

Tekla PowerFab
2021
Tekla PowerFab Tekla PowerFab GO

Take a single cut list item from stock

Use the TFS Entry command to take a single cut list item from stock. Tekla EPM will then process the cut list item and charge the purchased materials to the job. Note that the necessary materials need to be received in the purchase order before you can take them from stock.

  1. In the Production Control dialog box, click the Production Control ribbon tab.
  2. On the menu, select TFS Entry.
  3. To filter which items are shown:
    1. In the Production Control Purchasing Report Filters dialog box, select a filter type in the Type list, and click Select.
    2. In the Filter dialog box, click the arrow buttons to move the items that you want to see to the Included list.
    3. Click OK.

    Repeat steps a to c to set all of the necessary filters.

  4. Click Make Report.
  5. In the TFS Entry, select the desired cut list in the Cut List Serial # list.

    Only the items on the selected cut list are shown in the list below.

    Note that if any changes are made to the cut list, its serial number will no longer be valid.

    If you want to check the details of the selected cut list using reports, you can click Reports in the upper-right corner.

  6. In the list of items, select the item that you want to take from stock.
  7. Click TFS.
  8. In the Cut Lists dialog box, define the cut list properties and add drop lengths according to your needs.
  9. Click TFS to take the selected item from stock.

The item is removed from the inventory and charged to the current production control job.

Was this helpful?
Previous
Next