Set and update sequences

Tekla EPM
2021
Tekla EPM Tekla EPM GO

Set and update sequences

Use the Set Sequences command to set and update the sequences of main mark items in a production control job. Note that you should set sequences before combining materials for purchase.

  1. In the Production Control dialog box, click the Production Control ribbon tab.
  2. On the menu, select Modify Data > Set Sequences.
  3. In the Set Sequences dialog box, click the arrow buttons to move the items that you want to add to the same sequence to the right side of the dialog box.
  4. If you only want to add a specific number of pieces to the sequence, select the item on the right side of the dialog box and type a new value in the Quantity to Update field.
  5. Select the Update Sequence check box and type the new sequence number in the New Sequence field.
  6. If you want to update the lot number as well, select the Update Lot # check box and type the new lot number in the New Lot # field.
  7. Click Update Sequences.
  8. In the confirmation dialog box, click Yes to confirm setting the sequences.

    The sequences are set.

    Repeat steps 3 to 8 for all items whose sequences you want to set.

  9. To close the dialog box, click the Close button (X) in the upper-right corner.
Was this helpful?
Previous
Next