Set and clear filters

Tekla EPM
2021
Tekla EPM Tekla EPM GO

Set and clear filters

When you are viewing a job, you can sort the information that is shown by applying filters. You can filter job information by main mark, drawing number, sequence, lot number, and item category or sub-category. You can also modify the applied filters, set multiple filters, and clear the filters to view all job information again.

Set filters

  1. In the job view, tap the Filters () button in the upper-right corner.

    Any currently applied filters are shown.

  2. Do any of the following:
    • To set the filtering criteria by selecting check boxes, tap the Checkboxes button on the right side of the Filters dialog box.

    • To set the filtering criteria by selecting options in lists, tap the Select button on the right side of the Filters dialog box.

  3. Tap the arrow on the right side of the Select Filter list, and select the filter that you want to apply.
  4. Select the values that you want to use for filtering.

    For example, if you want to filter the job information according to the drawing number, select the desired drawing numbers.

    You can select multiple values.

  5. Tap Apply Filters.

    Only information that matches the filters that you applied is shown.

    To apply more filters, repeat steps 1 to 4.

Modify filters

  1. In the job view, tap the Filters () button in the upper-right corner.

    The currently applied filters are shown.

  2. Tap Edit under the filter that you want to modify.
  3. Select or add new values that you want to use for filtering.
  4. Tap Apply Filters.

    Only information that matches the filters that you applied is shown.

Clear filters

  1. In the job view, tap the Filters () button in the upper-right corner.

    The currently applied filters are shown.

  2. Do one of the following:
    • To clear one filter, tap Clear below the filter that you want to clear.
    • To clear all filters, tap Remove Filters.
Was this helpful?
Previous
Next