Initially, the same mesh properties are
applied globally to all meshed slabs. In order to adjust the global slab mesh properties,
see the following instructions.
-
Go to the
Project Workspace.
-
In the Structure tree, click Structure.
-
Go to the
Properties window.
-
Accept or adjust the Slab Mesh Size.
-
Accept or adjust the Slab Uniformity Factor.
At 100% uniformity all slabs in the mesh
will be of approximately equal area.
Tip: To optimize solution
time, you can use a coarser mesh during design development. Later, at the final
design stage, you can switch to a more refined mesh.
-
Accept or adjust the Slab
Mesh Type:
-
QuadDominant: mainly consists of quadrilateral 2D elements, but may use occasional
triangular elements to create a better mesh.
-
QuadOnly: only consists of quadrilateral 2D elements.
-
Triangular: only consists of triangular 2D elements.