If necessary, you can graphically modify the assumed punching shear check position. This allows you to determine the loaded perimeter when the perimeter is close to a free edge.
- Open a view and change the view regime to Review View.
- On the Review tab, click Show/Alter State.
- Go to the Properties window.
- In the Attribute list, select Punch check position.
- To change the punching shear check position, do one of the following:
To |
Do this |
---|
Switch the punching shear check position between Edge Z and Internal |
- Click the Z edge of a punching check item.
|
Switch the punching shear check position between Edge Y and Internal |
- Click the Y edge of a punching check item.
|
Switch the punching shear check position between Corner, Edge Z, Edge Y and Internal |
- Click a corner of a punching check item.
|
Note: Clicking an internal punching check item does not change the punching shear check position.
Tip: You can also box around multiple punching check item to switch their position. Do one of the following:
- Hold down the left mouse button and drag a box from left to right to switch the position setting of all punch check items within the box.
- Hold down the left mouse button and drag a box from right to left to switch the position setting of all punch check items within the box or cut by the box.