The Cantilever end command allows you to graphically apply cantilever ends where required to beams and columns.
- Open a view and change the view regime to Review View.
- On the Review tab, click Fixed / Pinned.
- Go to the Properties window.
- In the Attribute list, select Cantilever end.
- Set Mode to Set On, Set Off, or Toggle as required.
- Do one of the following:
- Click an individual member end to set/unset a cantilever end as per the Mode.
- Hold down the left mouse button and drag a box from left to right to alter the cantilever end settings of all members entirely within the box.
- Hold down the left mouse button and drag a box from right to left to alter the cantilever end settings of all members within the box or cut by the box.