Tube-MitreSaddle+Hole

Tekla Structures
2021
Tekla Structures

Tube-MitreSaddle+Hole

Tube-MitreSaddle+Hole connects a round tube to a round tube of equal diameter. The connection creates mitre holes to the main part and mitre cuts to the secondary part.

Objects created

  • Cuts

  • Welds

Use for

Situation

Description

Mitre saddle and hole connection.

Limitations

  • No support for polybeams.

  • Parts are only cut, not fitted. Short parts or parts at a steep angle may not show correct results.

Selection order

  1. Select the main part (round tube).

  2. Select the secondary part (round tube of equal diameter).

    The connection is created automatically when the secondary part is selected.

Parameters tab

Use the Parameters tab to control the mitre holes and cuts.

Connection options

Option

Description

Saddle + Hole

Creates a mitre cut (double mitre) to the secondary part, and a mitre hole to the main part.

Saddle Only

Creates a mitre cut to the secondary part. No mitre hole is created to the main part.

Hole Only

Creates a mitre hole to the main part. No mitre saddle is created to the secondary part.

Tube NC Parameters

Option

Description

Bevel angle

The weld preparation angle created during NC processing of the tube.

Root opening above

The gap between the parts. The gap is created in the model.

Shrinkage

The shrinkage considered during NC processing of the tube. The shrinkage value has no effect on the model.

Maximum torch angle

Maximum torch angle.

The default is 70.0.

Minimum torch angle

Minimum torch angle.

The default is -70.0.

Note:

Bevel angle information is used only in NC data, and no actual weld preparations are created in the model.

Weldings tab

Click the link below to find out more:

Create welds

General tab

Click the link below to find out more:

General tab

Analysis tab

Click the link below to find out more:

Analysis tab

Bylo to užitečné?
Předchozí
Další