Work with event sequences

Tekla Structural Designer
2021
Tekla Structural Designer

Add an event to the end of the event sequence

  1. On the Slab Deflection tab, click Event Sequences

    The Load Event Sequences dialog box opens.

  2. Go to the Model Event Sequence sub page.
  3. Click Add to Add the Event as the last event in the sequence.
  4. Name the new event and specify the event parameters according to your needs. If you want the same parameters to apply to custom events, ensure the Update custom event sequences box is selected.
  5. Click OK.

Insert an event within the event sequence

  1. On the Slab Deflection tab, click Event Sequences

    The Load Event Sequences dialog box opens.

  2. Go to the Model Event Sequence sub page.
  3. Select the event above which you want to insert the new event.
  4. Click Insert to insert the event.
  5. Name the new event and specify the event parameters according to your needs. If you want the same parameters to apply to custom events, ensure the Update custom event sequences box is selected.
  6. Click OK.

Re-order events in the event sequence

You can Add, Insert, Remove and Re-Order Events from the Model Event Sequence page.

  1. On the Slab Deflection tab, click Event Sequences

    The Load Event Sequences dialog box opens.

  2. Go to the Model Event Sequence sub page.
  3. In the Drawing Variant list, select the Event you want to move.
  4. ClickMove Up or Move Down until the Event is in the required position.
  5. Click OK.

Remove an event from the event sequence

  1. On the Slab Deflection tab, click Event Sequences

    The Load Event Sequences dialog box opens.

  2. Go to the Model Event Sequence sub page.
  3. Select the event which you want to remove.
  4. Click Remove to remove the event.
  5. Click OK.

Edit event parameters

  1. On the Slab Deflection tab, click Event Sequences

    The Load Event Sequences dialog box opens.

  2. Go to the Model Event Sequence sub page, or specific custom event sub page as required.
  3. Edit the event parameters according to your needs. If editing the Model Event Sequence and you want the same parameters to apply to custom events, ensure the Update custom event sequences box is selected.
  4. Click OK.

Edit event loadcases

  1. On the Slab Deflection tab, click Event Sequences

    The Load Event Sequences dialog box opens.

  2. Go to the Model Event Sequence sub page, or specific custom event sub page as required.
  3. In the left hand pane, expand the Event Sequence if required so that you can select the Event.

    The available and included loadcases are displayed.

  4. Move loadcases between the available and included lists as required. If editing the Model Event Sequence and you want the same loadcases to apply to custom events, ensure the Update custom event sequences box is selected.
  5. Click OK.

Create a custom event sequence

  1. On the Slab Deflection tab, click Event Sequences

    The Load Event Sequences dialog box opens.

  2. Go to the Event Sequences sub page.
  3. Click Add to add a new Custom Event.
  4. In the right hand pane click on the event name to rename it.
  5. In the left hand pane click on the event name in order to define the event parameters in the sequence.
  6. Click OK.

Apply a custom event sequence to a submodel

  1. On the Slab Deflection tab, click Event Sequences

    The Load Event Sequences dialog box opens.

  2. Go to the Submodels sub page.

    The table displays the event sequence assigned to each submodel.

  3. Use the droplist to change the Event Sequence assigned to a specific submodel as required.
  4. Click OK.
Bylo to užitečné?
Předchozí
Další