Display AsReq contours

Tekla Structural Designer
2021
Tekla Structural Designer

Display AsReq contours

AsReq contours can either be displayed as values, or as a pass/fail threshold. Displaying as a pass/fail threshold helps to visualize minimum patch sizes when optimizing panel and patch reinforcement as it highlights the specific areas in which the existing reinforcement is not sufficient.

  1. Open a view and change the view regime to Results View.

    The Results tab is opened on the ribbon.

  2. Set the analysis type and loading for viewing analysis results.
    Note: Typically the analysis method will be FE chase-down
  3. In the 2D Results group , select As Req.
  4. From the first droplist, select the desired direction and slab face.
  5. From the second droplist, select Value, or Pass/Fail as required.
Bylo to užitečné?
Předchozí
Další