Modify the setup of an inspection test
In the Inspection Test Setup dialog box, you can modify the testing requirements that the inspector will use for each test.
To access the Inspection Test Setup dialog box, do the following:
- At the bottom of the Test Records dialog box dialog box, click Inspection Test Properties.
To modify the testing requirements, do all of the following:
1. Modify the test properties
2. Add new fields
The field is added to the inspection test.
Repeat the process to create all necessary fields.
3. Modify, move, or delete fields
To |
Do this |
---|---|
Modify an existing field |
|
Move a field up or down |
|
Delete a field from the test setup |
Note that deleting a field from the test setup is permanent and cannot be undone.
|
4. Save the test and run a sample inspection test
When you have modified all necessary settings of the inspection test, save the test and run a sample test by adding a test record. You can later delete the sample test record.