Selection order of parts when creating System Component 149 with twin profiles
Not version-specific
Tekla Structures
Environment
Not environment-specific
Question:
What is the correct selection order when creating the Brace Middle Simple (149) component, when I have 8 braces to connect to one plate?
Answer:
Change the “Up direction” on the General component tab to +x instead of Auto.
The selection should start from the back side (-x direction), go from +y to -y direction, then the front side, go from +y to -y direction.
What is the correct selection order when creating the Brace Middle Simple (149) component, when I have 8 braces to connect to one plate?
Answer:
Change the “Up direction” on the General component tab to +x instead of Auto.
The selection should start from the back side (-x direction), go from +y to -y direction, then the front side, go from +y to -y direction.
Image